词语站>英语词典>wall plug翻译和用法

wall plug

英 [ˈwɔːl plʌɡ]

美 [ˈwɔːl plʌɡ]

墙上插座

英英释义

noun

双语例句

  • Wall shear stress method integrates the plug flow displacing, the low speed displacing and the turbulent flow displacing methods in theory.
    壁面剪应力设计方法,从理论上把塞流顶替、低速顶替及紊流顶替技术统一起来。
  • The process schedule to improve non-uniform shell wall thickness on plug mill is investigated.
    研究了在自动轧管机上减小荒管壁厚不均的工艺方案。
  • The wire snapped at the wall plug with a blue flash and the light fused
    墙上插头处的电线啪地发出一道蓝光,电灯的保险丝烧断了。
  • It is described in this paper how to get an adequate geometry of the piercing plug, including the taper length, nose thickness and the plug wall thickness, when conducting design of the said plug.
    前言:介绍了在顶头设计中,如何正确选择穿孔锥长、鼻端厚及顶头壁厚的几何尺寸。
  • Non-uniform wall thickness of steel pipe rolled on plug mill
    自动轧管机组轧制钢管壁厚不均问题的研究
  • The wire snapped at the wall plug and the light fused
    墙上插座的电线短路烧断了保险丝,电灯跟着灭了。
  • The results show: at lower pressure ratio, heat transfer condition on the plug surface is the worst, peak values of pressure and temperature appear along the wall of plug nozzle, temperature and temperature gradient along the section of wall reach the highest.
    计算结果表明塞式喷管发动机在较低压比的工况下工作时,塞锥受热状况较为恶劣,塞锥壁面出现压强和温度的峰值,该截面内部的温度和温度梯度达到最大。
  • The experiment shows the wall shear stress and the Sherwood number follows an analogous law. Their minimum appears at the nose of gas plug, while their maximum appears at the bottom of gas plug.
    实验结果说明,壁面剪应力与Sherwood数的变化规律类似,在弹状泡顶部达到最小。
  • The pressure distributions on the wall surface of the plug nozzle models with two different truncated length were measured under different nozzle pressure ratios and the schlieren photos of typical cases were taken.
    实验模型采用直排的点膨胀构型,实验测量了两种塞体长度的塞式喷管在不同压比条件下的表面压强分布,拍摄了典型工况下流场的纹影照片。
  • Water plug was introduced and TTAB on the capillary inner wall could be dissolved into the water plug, which enhanced negative zeta potential of the capillary section.
    再以高差法引入水塞,吸附于毛细管壁的TTAB溶解到水中,使该段毛细管的zeta电势变负;